MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT – Orlando Shop

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT


MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT
Price: US$16.99
Free Shipping





MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT

Overview:
The Fokker E.III was the main variant of the Eindecker (monoplane) fighter aircraft of World War I. It entered service on the Western Front in December 1915 and was also supplied to Austria-Hungary and Turkey.

The E.III was basically an E.II fitted with larger, newly designed wings that had a slightly narrower chord of 1.80 meter (70-7/8 in), compared to 1.88 meter (74 in) on the earlier Eindeckers, going back to Fokker's original M.5 monoplane aircraft. The E.III retained the same 75 kW (100 hp) Oberursel U.I engine, and therefore also used the larger diameter "horseshoe" pattern cowling that also mandated the inclusion of the E.II's soffit-like extensions to the sides of the upper nose sheet metalwork, but had a larger 81 l (21.5 gal) drum-shaped main fuel tank just behind the cockpit, which increased the Eindecker's endurance to about 2½ hours; an hour more than the E.II. Most E.IIIs were armed with a single 7.92 mm (.312 in) Spandau LMG 08 machine gun with 500 rounds of ammunition; however, after the failure of the twin-gun Fokker E.IV as a viable successor, some E.IIIs were fitted with twin guns.

Specification:

Brand Name: MinimumRC

Item Name: Fokker E3

Type: KIT, KIT with motor(optional)

Wingspan: 420mm

Length: 380mm

Material: 1mm Balsa wood + 1mm laminate

Flying Weight: 25-30g

Package Weight: About 160g



Recommended Parts (Not Included):

Motor: 716 coreless, Click Here

Servo: 1.7g *2, Click Here

Receiver: Micro 1s 3CH receiver, Click Here

Transmitter: 2.4G 4CH, Click Here

Battery: 1S 3.7V 150mAH 1.25 JST



Note:

The KIT verison doesn't include any electronic device.
The KIT with motor version comes with a 716 coreless motor and a 138mm propeller.
Please select the version you prefer.




Install Manual, Click Here



Package Included:

1x MinimumRC Fokker E3 420mm Balsa Wood Laser Cut RC Airplane KIT

You Might Also Like: