HSP 2.4G 3CH transmitter for all rc car and boat
Note:This product included small parts and pay attention to not to swallow it.
Suitable:All rc car and boat
All the products should be used by the aged above 6 years old.
Transmitter size: heght:23.5cm width:13cm
Receiver size: length:3.6cm
The new MT-305 is an upgraded version of the MT-300. Not only does the appearance update beautiful, but the receiver also adds a waterproof silicone sleeve. In addition to the original steering stroke adjustment, the throttle stroke adjustment is newly added. The third channel switch, the remote control power supply low-voltage sound. Sound alarm and other functions. The built-in antenna no longer has to worry about breaking the antenna, and it is more user-friendly. New car remote control, without packaging (MT-305 and MT-300 receiving universal,but the FLysky transmitter is not suitable)
MT-305 2.4g car / marine three-channel remote control Novel design Three channels Built-in antenna Out of control protection Simulator signal output.
MT-305 2.4g remote control transmitter and receiver pairing [pair frequency]
First turn on the power of the transmitter, press and hold the pairing/setting button on the receiver, then turn on the power of the receiver. At this time, the LED on the receiver starts to flash rapidly. Press the pairing button on the transmitter for 10 seconds. More than two seconds [the LED on the transmitter starts flashing rapidly] until the receiver's LED is not flashing.
MT-305 2.4g remote control Out of control protection setting method [FAIL-SAFE]
The setting of FAIL-SAFE is only allowed in the state where the transmitter is connected to the receiver, and other functions are not performed in other states. When the transmitter is connected to the receiver [Receiver LED light is on] After cutting the position of CH1 CH3 to the position to be set, press and hold the pairing/setting button on the receiver for more than 2 seconds to enter the setting of FAIL-SAFE. Constant mode [LED slow flashing], then press and hold the button for more than 1 second in 5 seconds [more than 5 seconds or more without pressing the button to return to the normal mode without FAIL-SAFE setting] Save the set value At this time, the LED flashes rapidly and returns to the normal acceptance mode after completion. To cancel the function of FAIL-SAFE, just re-pair the transmitter and receiver.
The remote control requires an additional 4 AA alkaline or rechargeable batteries.