Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver


Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Price: US$24.99
Free Shipping





Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver

Description:
Brand Name: Eachine
Item Name: SKYkylin-F3 Brush Flight Controller
Dimension: 22mm*33.5mm
Weight: 3.5g

Features:
1.SKYkylin-F3 based on F3_EVO Brushed Flight Control Board,suit for coreless motor brushed racing quadcopter.Powerful MCU processor have a better flight experience.
2.It is integrated the FRSKY Compatible 8CH receiver(Serial port output) into the flight controller. Distance far, signal return, signal stability.
3.The flight control support 1S (4.2V) and 2S (8.4V) power supply.Strong power settings, both at 1S and 2S, have 1A output current, ensure flight controller and external equipment stability.
4.Integrated with DCDC voltage booster circuit, it can supply power for other device through IIC and UART port.(5V and 3.3V voltage output interface)
5.Frequency for driving motor: 2000 (the frequency can be set up by user, max frequency can be 32K)
6.Support SBUS,DSM satellite, PPM receiver input signal.

Notice:

Before applying power, pay attention to the battery voltage selection.
The default shipping is 1S (4.2V); When using 2S, first need to disconnect the short contacts 1S, and then put the two pads on the 2S.
Prohibit shorted together the three pads at the same time.
Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver
Binding:
1.Turn on X9D transmitter, select D8 mode.Select bind and press ENT key:

Eachine SKYkylin-F3 Brushed Flight Control Board Built-in FRSKY Compatible 8CH Receiver

2.Holding the receiver button,and power the receiver, the blue LED on the receiver is solid.Released the receiver button, the blue LED goes out.(At this point, the receiver lights out, is set out of Failsafe, please set up the transmitter channel which need to set up failsafe, the proposed throttle position is the lowest, lock the switch lock, mode switch in the self stabilization mode)
3.Select bind and press ENT key,the blue LED on the receiver is flashed,power the receiver,the blue LED on the receiver is solid, means binding successful.

3.The Green LED on the receiver will turning off,this indicate that the bind process was successful.Reconnect the battery,and the green LED on the receiver is solid again.

Ground station configuration:
1. In CF software configuration UART3 to Serial RX,and change the Receiver mode to RX_SERIAL,and then set up the receiver brand with SBUS.
2. In the CLI command interface, input "set motor_pwm_rate=1000 ",Press enter,and then input "Save" command to save.

Package included:
1 x SKYkylin-F3 Brushed Flight Control Board

You Might Also Like: