Processor: STM32F303 72Mhz
Gyro Accelerometer: MPU6500
Working Voltage: 3.3v-4.2v(1S Lipo)
Firmware Version: Cleanflight 1.13.0
Built-in Receiver: FRSKY 8CH SBUS Receiver
Compatible Transmitter: FRSKY X9D/X9D PLUS
Default Receiver Channel Map: TAER1234
Default Unlock Channel: AUX1(Channel 5)
1.FRF3_EVO Brushed Flight controller is an integrated Frsky compatible 8CH SBUS protocol receiver,based on F3_EVO Brushed Flight Control Board.
2.It is integrated the FRSKY receiver into the flight controller, avoid the welding trouble, and the installation is more convenient, suitable for ultra small brush racing quadcopter.
4.Support Rate Mode and Angle Mode.
4.Support FRSKY X9D/X9D PLUS(D8 mode),and XJT (D8 Mode),DJT DFT DHT Transmitter
5.With a 4-axis large current NMOS transistors, operating current of up to 10A or more.Support almost all hollow cup motor, including 1020 coreless motor.
6.With VBAT voltage detection, external buzzer interface, LED_Strip function, also can be configured WS2812 light.
The flight controller default has been set up receiver mode, bind and play.
1.Soldering the bind pins, and then connect the battery, the Green LED is solid,this indicate receiver is in binding mode.
2.Turn on the transmitter, select D8 mode for the receiver.click the
3.The Green LED on the receiver will turning off,this indicate that the bind process was successful.Reconnect the battery,and the green LED on the receiver is solid again.
1 x FRF3_EVO Brushed Flight controller