Processor: STM32F303 72Mhz
Gyro Accelerometer: MPU6500
Working Voltage: 3.3v-4.2v(1S Lipo)
Firmware Version: Cleanflight 1.13.0
Built-in Receiver: DSM2 6CH PPM Receiver
Default Receiver Channel Map: TAER1234
Default Unlock Channel: AUX1(Channel 5)
It supports most Spektrum and JR series transmitter
Support Walkera DEVO10 DEVO7E running deviation firmware transmitter
Sopport all of transmitter base on DSM2 protocol
1.DSF3_EVO Brushed Flight controller is an integrated DSM2 compatible 6CH PPM protocol receiver,based on F3_EVO Brushed Flight Control Board.
2.It is integrated the DSM2 receiver into the flight controller, avoid the welding trouble, and the installation is more convenient, suitable for ultra small brush racing quadcopter.
3.Support Cleanflight / Betaflight.
4.Support Rate Mode and Angle Mode.
5.With a 4-axis large current NMOS transistors, operating current of up to 10A or more.Support almost all hollow cup motor, including 1020 coreless motor.
6.With VBAT voltage detection, external buzzer interface, LED_Strip function, also can be configured WS2812 light,Auto-bind function.
1.Connect the battery,waiting receiver to get into binding mode.The Blue LED will blinking slowly,and it will binking fast after 5sec,this indicate receiver is in binding mode.
2.Turn on the transmitter and Enter into Binding mode, the Blue LED on the receiver will turn off and then get be solid,this indicates binding successfully.
3.Blinking slowly meand loose the signal from transmitter.
1 x DSF3_EVO Brushed Flight Control Board