Brand Name: Eachine
Item Name: CC3D_Brush Flight Controller
1. CC3D_Brush Flight Controller is in the revision on the basis of the CC3D hardware, it is a 32bits brush flight controller based on Openpilot firmware.
2. The flight control support 1S (4.2V) and 2S (8.4V) power supply, 2S power can bring flying experience more violence.
3. Independent design of the circuit structure, comes with the pressure reduction technology, whether it is 1S or 2S power input, UART1/2 output 5V, UART3 output 3.3V
4. Using STM32F303CCT6 + MPU6500, advanced hardware platform F3 guarantee more stable flight,support Tricopter/Quadcopter/Hexacopter.
5. With a large current NMOS transistors, operating current of up to 10A or more.
6. Support for PWM, PPM, SBUS, DSM receiver input signal.
7.In support of the world almost all hollow cup motor, including 1020 coreless motor.
Before applying power, pay attention to the battery voltage selection.
The default shipping is 1S (4.2V); When using 2S, first need to disconnect the short contacts 1S, and then put the two pads on the 2S.
Prohibit shorted together the three pads at the same time.
1 x Eachine CC3D_Brush Flight Control Board